Inferno SRPH68 Manuel d'instructions

Outdoor Flame HeaterOwner’s ManualRead these instructions before lighting this appliance.This appliance must be installed in accordanceto municipal an

10SAFETY CHECK Check for leaksAll connection on the patio heater have beenchecked for leakage at the factory. Follow these steps to check the gas hose

OPERATION111. Ensure control knob is in OFF position.2. Depress control knob and turn counter clockwise to IGNITE.3. Continue to depress knob for

OPERATION12Note: The burner may be noisy when initially turned on.To eliminate excessive noise from the burner, turn the control knob to the Minimum p

OPERATION13

14LOCATING HEADER FOR USE CAUTION: WHEN CERTAIN MATERIALS OR ITEMS ARE LEFT, ABOVE, BESIDE OR UNDERTHIS HEATER WHILE IN USE, THEY WILL BE SUBJECT TO R

15MAINTENANCE/STORAGEDO NOT touch or move heater forat least 45 minutes after use. Allowall burner elements to cool beforetouching.FOR YOUR SAFETY ; W

16MAINTENANCE/STORAGENOTE:wait until heater is cool before covering.Turn the control knob to "OFF" position.Turn LP cylinder to "OFF&qu

TROUBLESHOOTING17

18The appliance has been manufactured under the highest standards of quality and workmanship. Wewarrant to the original consumer purchaser that all as

2This appliance can produce carbon monoxidewhich has no odor.Using it in an enclosed space can kill you.Never use this appliance in an enclosed space

3The installation must conform with local codesor, in the absence of local codes, with theNational Fuel Gas Code, ANSI Z223.1/NFPA 54,NFPA58 Natural G

4The pressure regulator and hose assembly sup-plied with the appliance must be used, replace-ment pressure regulators and hose assembliesmust be those

5This heater is designed to operate with a standard 20 Ib propane cylinder with Approved Cylinder Connection.NOTE: PLEASE READ THE FOLLOWING SAFETY RU

6PARTS CONTENTSPlease check the contents of the packaging as to whether anything is missing! A hinged metal door is provided foreasy access to the LP

7ASSEMBLY INSTRUCTIONS Step 1Step 2Step1: To assemble unit-partially open gas chamberdoor.Carefully lift dome until entire heat exchange tubeis expose

ASSEMBLY INSTRUCTIONS8213Step 4Step4: Fully open gas chamber door. Remove knobfrom door and place on control stem.Warning:This appliance requires inst

9ASSEMBLY INSTRUCTIONSAA(not included) Battery(1.5V)Step 5Step 6+-AAStep5: Place battery incompartment below control panel.Warning:This appliance requ